
Gas Fireplace Service & Cleaning
Annual tune-up by licensed gas techs. We inspect, clean, and certify your gas fireplace so it runs safely, efficiently, and reliably all season long.
Special Offer
$299
Annual Service & Cleaning
See our team on a real Florida install
This isn't stock footage. Watch our licensed gas-fireplace crew on an actual project inside a large South Florida home — from custom framing and gas line work to the final flame test. What you see is what you get when V2 Gas Fireplace Pros shows up at your door.
- Licensed & insured gas techs — not subcontractors
- 18+ years of gas-only fireplace craftsmanship
- In-house crew that treats your home like a design brief
Why Your Gas Fireplace Needs Annual Service
Even though gas fireplaces burn clean compared to wood, they still accumulate dust, spider webs, lint, and corrosion — especially in Florida's humid, salty coastal air. Manufacturers and your homeowner's insurance both recommend an annual professional service. V2 Gas Fireplace Pros performs a full multi-point inspection: gas pressure test, leak check, thermocouple and thermopile readings, pilot adjustment, burner and log cleaning, glass and gasket inspection, venting check, carbon-monoxide test, and safety shut-off verification. You get a written report with photos and any recommended repairs — no upsell pressure. Most service visits take 60–90 minutes and the $299 visit is credited toward repairs if anything is needed.
What's Included in Every Service Visit
Full Safety Inspection
Gas pressure test, soap-bubble leak check on every fitting, manometer verification, and safety shut-off testing on both pilot and main valve.
Burner & Log Cleaning
We remove every log, vacuum the firebox, brush the burner pan, clean the ember bed, and reassemble the log set exactly per the manufacturer's diagram for the correct flame pattern.
Pilot & Ignition Tuning
Adjust pilot height, clean the pilot assembly, test thermocouple and thermopile millivolt output, and verify clean ignition on standing-pilot and IPI/electronic systems.
Glass, Gasket & Door Service
Remove front glass, clean both sides with non-abrasive fireplace cleaner, inspect the gasket seal, and reinstall with the correct torque pattern to prevent leaks.
Carbon-Monoxide Test
We run the unit at high fire and test combustion byproducts with a calibrated CO meter to confirm safe, clean burn.
Venting & Termination Check
Inspect direct-vent termination cap, screens, and exterior penetration for blockage, corrosion, or pest intrusion — a Florida-specific concern for coastal homes.
Remote, Switch & Battery Service
Replace receiver and remote batteries, verify wall-switch wiring, and test smart-home or thermostat integrations.
Written Photo Report
Emailed PDF with photos of every checkpoint, millivolt readings, recommendations, and a sticker on the unit showing the next service due date.
What to Expect at a Gas Fireplace Service Appointment
A proper annual service is not a 10-minute visual check. From the moment we arrive, the visit follows a fixed protocol so nothing gets skipped. Here's how a typical 60–90 minute tune-up runs:
- Walk-through & symptoms. Before opening the unit, we ask how it's been running, when it was last serviced, and whether you've noticed any pilot or odor issues. Saves diagnostic time later.
- Shut off and disassembly. Gas off at the appliance valve, front glass removed, log set photographed in place (so it goes back exactly the same), then logs and burner pan out.
- Deep clean. Burner ports brushed, ember bed vacuumed, pilot hood and thermocouple/thermopile tips polished, blower squirrel cage cleaned.
- Component testing. Millivolt readings on thermocouple (target 25+ mV) and thermopile (target 300+ mV closed circuit). Gas pressure tested with manometer at the valve.
- Leak check. Every fitting from the shut-off to the burner brushed with soap solution and watched for bubbles. Non-negotiable on every visit.
- Reassemble & fire. Logs returned to manufacturer spec, glass reset with new gasket if needed, unit lit, flame pattern verified.
- Combustion test. Calibrated CO meter at the room, draft check at the vent termination.
- Written report. Photos of every checkpoint, millivolt readings, recommendations, and a service sticker on the unit with the next due date.
Common Problems We Catch During Service
Roughly 1 in 3 annual tune-ups turns up something the homeowner didn't know about. These are the issues we find most often — caught early at the service visit, before they become a no-heat call in January.
Weak thermocouple millivolt output
Pilot will work fine for now but will start dropping out within a season. Cheap swap.
Slight gas leak at a flare fitting
Found with the soap test. Tightened or re-flared on the spot.
Spider webs in the pilot tube or burner orifices
The #1 cause of no-light calls in spring. Cleared during the deep clean.
Cracked or rotted door gasket
Causes glass fogging and combustion drift. Replaced with OEM gasket rope.
Corroded vent termination cap (coastal homes)
Salt-air damage. Replaced before it restricts draft.
Dead remote batteries or paired-out receiver
Quick reset that saves a service call later.
Gas Fireplace Service by city in Florida
Local pricing, response times, and FAQs for gas fireplace service in every city we cover — from Palm Beach to Jacksonville.
- Gas Fireplace Service in West Palm Beach
- Gas Fireplace Service in Boca Raton
- Gas Fireplace Service in Wellington
- Gas Fireplace Service in Port St. Lucie
- Gas Fireplace Service in Vero Beach
- Gas Fireplace Service in Melbourne
- Gas Fireplace Service in Daytona Beach
- Gas Fireplace Service in Palm Coast
- Gas Fireplace Service in Jacksonville
- Gas Fireplace Service in St. Augustine
- Gas Fireplace Service in Gainesville
- Gas Fireplace Service in Orlando
- Gas Fireplace Service in Ocala
- Gas Fireplace Service in Kissimmee
- Gas Fireplace Service in Lakeland
- Gas Fireplace Service in Tampa
- Gas Fireplace Service in Jupiter
Frequently Asked Questions
How often should a gas fireplace be serviced?
Once a year — typically in the fall before you start using it. Manufacturers require annual service to keep the warranty valid, and most homeowner's insurance policies expect it for gas-appliance coverage. Coastal Florida homes within 5 miles of saltwater benefit from twice-a-year service.
How much does gas fireplace service cost?
Our flat-rate annual tune-up is $299 and includes the full multi-point inspection, cleaning, and written report. There are no trip fees, no per-component charges, and the $299 is credited toward any repair if we find something that needs fixing.
Do you service vent-free (ventless) units too?
Yes. Vent-free units actually require closer attention because they exhaust combustion byproducts into the room. We test oxygen-depletion sensors (ODS), clean the precision burner, and verify CO output meets the strict vent-free spec.
What brands do you service?
Every major gas-fireplace brand — Heat & Glo, Majestic, Napoleon, Mendota, Valor, Empire, Heatilator, Monessen, Lennox, Astria, Superior, and more. We carry common ignition, valve, and thermocouple parts on the truck for same-visit fixes.
What if you find a problem during the service?
We pause, show you the issue with photos, and give you a flat-rate repair quote on the spot. You decide whether to repair now, schedule it, or skip it. No surprise charges and no pressure.
Ready to Get Started?
Our experts are standing by to help with all your chimney and fireplace needs. Schedule your service today!
Schedule OnlineWhy Choose V2 Gas Fireplace Pros
Florida's gas fireplace specialists — trusted by homeowners for honest repairs, clean installs, and safe, reliable gas service.
